SOLTRA

Just so that everyone is aware, there were some changes made to a few rules. The new rules are on the web site.

Below are the affected rules, and where they can be found...but please be sure to FULLY read the amended rules so as to familiarize yourselves with them.

The changes are as follows....(in bold)

General rules

    b) All shields and guards (including dash boards) must be in place as determined by the tech inspector. NO open debris screens on rear-engine tractors. There must be a device in place to keep fingers, hair etc. from coming into contact with debris screen. All gaps between seat and fenders must be filled. Any exhaust pipes exiting outside the tractor chassis must be covered with a suitable heat shield.

S. Stock

9. Rear bumpers are mandatory. Bumpers must be made of square or round tubing, a minimum 1 1/4”, but not to exceed 2” o.d. or 2” sq. (all sharp corners/edges must be removed). Bumper must be mounted so that it is aligned with center of rear wheels and must be of one piece design. Optional bars may be added above or below this bumper. Bumpers are not to be wider than overall width of axles (outside of tire to outside of tire). Sidebars are highly recommended (refer to rule #18 in modified for specs.)

Mod.

16. Rear bumpers are mandatory (fronts are optional). Bumpers must be made of square or round tubing, a minimum 1 1/4”, but not to exceed 2” o.d. or 2” sq. (all sharp corners/edges to be removed). Bumper must be mounted so that it is aligned with center of wheel and must be of one piece design. Optional bars may be added above or below this bumper. Bumpers are not to be wider than overall width of axles, outside of tire to outside of tire.

S. Mod.

12. Rear bumpers are mandatory (fronts are optional). Bumpers must be made of square or round tubing, a minimum 1 1/4”, but not to exceed 2” o.d. or 2” sq. (all sharp corners/edges to be removed). Bumper must be mounted so that it is aligned with center of wheel and must be of one piece design. Optional bars may be added above or below this bumper. Bumpers are not to be wider than overall width of axles (outside of tire to outside of tire).

Thank you, in advance, for your usual co-operation.

Does the dassh have to be stock or can we custom fab one? Couldnt find anywhere in the rules that says one way or the other